Aris Makina & Otomotiv
← Cold chain guide hub

What we have written on the cold chain120 / 154

More articles from the Isotec guide hub: choosing containers, eutectic plates, measurement, regulation and notes from the field.

Which records help manage adhesive and sealant stock?
23 September 2023
Which records help manage adhesive and sealant stock?

Track lot, expiry and supplier storage conditions alongside stock movements.

Read the article →
How to decide at the dock when a load is not pre-cooled
22 September 2023
How to decide at the dock when a load is not pre-cooled

Compare loading measurements with product acceptance conditions. If they do not align, escalate before dispatch.

Read the article →
How to make a repeated deviation visible
19 September 2023
How to make a repeated deviation visible

Log repeated exceptions by shift and process, then review the written procedure alongside actual practice.

Read the article →
What temperature trends should a control chart show?
18 September 2023
What temperature trends should a control chart show?

Sequence readings from the same route and product group to distinguish process changes from actual deviations.

Read the article →
How to manage different temperature needs in groupage
15 September 2023
How to manage different temperature needs in groupage

Record compartment, container, and route performance separately; validate mixed-load compatibility in a trial.

Read the article →
Prioritize cold-chain risks with evidence-based FMEA
12 September 2023
Prioritize cold-chain risks with evidence-based FMEA

Record failure mode, effect, occurrence evidence and detection with the team; build a shared priority rationale instead of inventing scores.

Read the article →
Where does the cold chain break at shift handover?
9 September 2023
Where does the cold chain break at shift handover?

A handover record shows load position, status, last reading, sensor, open issue, next action, owner and acceptance together.

Read the article →
How to find the cause of condensation in cold transport
7 September 2023
How to find the cause of condensation in cold transport

Measure where droplets form, dew point and surface temperature together; choose a remedy based on the findings.

Read the article →
A setup where the mistake cannot happen: poka-yoke in the cold chain
6 September 2023
A setup where the mistake cannot happen: poka-yoke in the cold chain

Poka-yoke comes in two kinds: one stops the process when a part is placed wrongly, the other flags the abnormal. On GEBHARDT plates the closure colour warns, and the freezing rack guarantees the air gap by its construction.

Read the article →
Putting a household fridge in a van: where does the power come from
5 September 2023
Putting a household fridge in a van: where does the power come from

With the engine running the alternator feeds the fridge; once it stops the load falls on the battery. A 100 Ah battery holds 1.2 kWh in total and a starter battery cannot be deep-cycled.

Read the article →
What determines a sandwich-panel quotation?
4 September 2023
What determines a sandwich-panel quotation?

Compare panel build, doors, joint components, delivery and installation against one shared specification, not price per area alone.

Read the article →
The freezing limit for paints and chemicals: one night is enough
3 September 2023
The freezing limit for paints and chemicals: one night is enough

Water-based paint is irreversibly damaged below the freezing point. Ankara's average January low is -3.1 °C, so an average January night falls below that limit.

Read the article →