BlogPage 135 / 155

Do not simply add the first batch to an existing route. Verify product needs, packaging, receipt and temperature records in a limited pilot.

The box average does not show contact risk. Place sensors against the actual product layout and assess the result.

GEBHARDT Isotec TBX can be washed by hand, with a pressure washer or in an automated washing line. For an audit, what counts is a wash log and a seal check.

Determine document requirements by checking country, route, product, equipment scope and contract together.

A half-frozen pack and a warm box use up part of the calculated time before the shipment leaves. Conditioning is the performance step that needs no extra investment.

A foam box has no hours of its own; wall, coolant and outside air decide it. Worked example: a 46-litre EPP box with 31 mm walls stays cold for about 7 hours with 2 kg of ice at 25 °C.

Assess manufacturer nesting data for the Rocotec model separately from measured containers and vehicle capacity on empty returns.

According to the EPS industry association EUMEPS, the EU recycling rate for post-consumer EPS packaging is about 40 per cent. That is industry data; your own site's rate comes from monthly records.

A refrigerated trailer's internal size is smaller than its outside; at 13.4 m internal length the count comes to 33 pallets. The stacking plan is built on net internal size, air clearance and axle distribution.

Compare tested performance, usable volume and total cost under the same route and load.

Separate odour, brine and cleaning needs by product; verify the container against the real route and wash method.

Age alone is not a diagnosis: inspect panels, seals, holes, unit service, route and sensors as separate field trends.

Both work by phase change; for medicines the choice turns on the temperature at which the pack goes into the box. A pack straight from the freezer, or a frozen gel pack, can freeze a 2-8 °C product.

Announced or not, when the power goes the clock starts on everything in the cold room. What decides the outcome is a closed door, a pre-frozen plate and a measurement after the cut.

Compartment count alone proves little. Check seals, air paths, evaporator capacity, door profiles and representative sensor records together.

EPS is a good insulator but the box does not set the duration. We work out the ice a 30 mm wall box needs for 24 hours, then look at the three variables that remain.