What we have written on the cold chain94 / 154

Do not assume equal width or crate fit. Check external and internal dimensions for the exact model code, then trial with your packaging.

Compare maker dimensions with door, vehicle and turning clearance; the TBX 410's 410 L volume alone does not show fit.

Before interpreting a curve, verify the model, load, ambient conditions, sensor location and test method.

Sublimation is the kind of phase change that goes straight from solid to gas, which is how dry ice is used up. A eutectic plate works between solid and liquid at a chosen melting point and is frozen again.

The ambient-to-interior difference affects heat transfer; hold time may not change linearly. Record shade, wind and load.

Compare quotes by lambda, panel U-value, complete-body performance and matched test conditions, then request the holding-hours protocol in writing.

Simple curve models explain behaviour; they do not guarantee duration. Record sensor location and conditions with the actual load.

Compare calibration status, sensor location and measurement time. Do not choose a reference until both devices measure the same item and point.

If the cable affects lid closure, the measurement setup has changed. Verify a manufacturer-defined pass-through or route it outside the seal.

Review battery performance by cell type, device and use conditions. If records have gaps, compare battery, temperature and communication logs.

A glycol bottle imitates a defined thermal response; do not assume product equivalence. Trial its fill, volume and placement against the load.

An infrared thermometer reads the radiation a surface emits. On a shiny surface it sees the reflection of its surroundings instead of the product's heat, so the acceptance decision rests on a probe placed between packs.