BlogPage 60 / 155

Ask separately about product, import, sales and service roles. Match company and product documents to order, parts and service contacts.

A shelf and plate layout does not guarantee two independent temperature bands in one container. Assess suitability with a real-load route measurement.

Rack compatibility with a blast freezer depends on dimensions, airflow and approved use. Determine freezing time by trial.

Base dimensions alone do not establish fit. Verify loaded weight, contact area and stability on the actual route.

Tub, plate and holder arrangements can vary by model. Check article-code fit and access with the actual load.

Compare product, stops, handling and tested thermal profile to decide where a handoff belongs.

Compare load centre, platform, gradient and total weight with the lift's own diagram and instructions.

Castors are a convenience in the warehouse and a height problem at the vehicle door. Fixed dock, portable ramp, tail lift and hand lifting suit different container weights and bed heights.

Do not run a train until couplings, load, turns and stopping are checked against equipment limits.

Choose from equipment fit, trip frequency, floor conditions and observed task time.

Aisle width is set by the area a container sweeps when turning, not by its width. On the TBX 725 (757 x 954 mm) the diagonal is 1218 mm.

Validate open-container dimensions, drainage, drying and hourly workflow together on site.

A threshold of a few centimetres is the smallest obstacle that stops a loaded container. A small plate cuts the push force many times over, but its capacity and fixing set the limit.

Give the engineer load, wheel contact and traffic path data; track floor damage by route.

Have users trial real loading and delivery tasks, then record observations and concerns in the decision.

Time the same tasks with each container; verify insulation separately from handling speed.